Those who are familiar with the HTV industry know that the hot stamping and engraving of the htv are two very important steps, which play a decisive role in the result of the entire HTV. Today I will talk about the HTV. Few tips you have to know.
The first thing to talk about is the adjustment of the htv cutting . The cutting machine should pay attention to important points such as knife pressure, angle, speed, etc. If the speed is too fast, the knife will easily jump, resulting in continuous cutting. Remember to establish the test angle, knife pressure, speed, etc. before engraving. You must wait for the sample to be successful before mass production!
Second, the waste discharge of the htv.
The second is about the waste discharge of the htv. If it is a large pattern, it is better to discharge waste. Small patterns, small letters, or some special-shaped patterns can be discharged with the help of some small tools, such as tweezers or hooks. In the operation process, also remember that “smaller first, then large” means to arrange the small patterns first, and then arrange the large patterns!
Another common problem is that some products are prone to pattern drop. At this time, we can boldly use double-sided tape for conventional hot pressing after re-adhesive, but this is only for release products, assuming that it is adhesive Types of products can be directly glued back and then pressed. In this case, double-sided tape is not needed.
Some friends will ask, what if there are too many small patterns? It seems that efficiency cannot be so high. At this time, we recommend that you use adhesive products, this series of products are more suitable for carving some fine patterns.
