Four steps for car glass film installation:
1. Glass inner cleaning
Clean the glass label glue, remove the oily paint, etc., thoroughly clean the car glass no less than 2 times.
2. Install window film
Spray clear water on the cleaned glass, tear off the protective film of the car window film, and spray clear water on the surface of the window film, then the window film can be attached to the car glass.
3. Catch water
The top side door uses a large white scraper to drive out the water between the window film and the glass, and the conventional side door uses a large blue scraper to drive out the water between the window film and the glass.
4. Finishing
Use suede to close the edges of the window film and where there are bubbles to keep the film and glass perfectly fused.
Note: These four points are a rough construction process. If you want to meet the professional window film construction standards, you have to go to a professional window film construction shop for construction.
