1. If the thermal transfer film has a protective liner, tear it off to expose the adhesive or cut portion of the film.
2.Feed vinyl to your plotteyor cutter. Materials do not require any special settings.
3. Using a vinyl weeding tool or hook, remove excess vinyl from the printed paper, leaving only the portion of the design you wish to transfer to the fabric.
4. Place the graphic on the target area. Make sure the surface is flat and remove any residue. Has a built-in tear-off surface. No transfer paper required.
5. Using a press or an iron, apply medium pressure with the iron set to 150°C for about 10-15 seconds.
6. According to different lettering film, it can be cold peeled and hot peeled. Tear off the backing paper. If the design lifts up, you can cover with PET paper and iron again for 8-10 seconds.
