1. The working environment of the sticker is better between 15 °C and 30 °C. Because the temperature is too high, the film will become larger, and the wet solution will evaporate rapidly. If the temperature is too low, the film will be flexible and affect the adhesion.
2. Thoroughly clean the body surface with water and a neutral detergent. In order for the color strip to be properly attached, the surface of the body must be free of dust, wax and other dirt.
3, the sticker is divided into three layers, the bottom paper (white glass paper), the PVC sticker itself, the transfer film and the protective film (transparent), and the surface protective film is removed after the final completion. During the process of attaching, be careful not to pull the sticker hard to prevent deformation.
1. Determine the pasted parts according to the drawings and compare the dimensions.
2. Clean the parts of the body that need to be glued:
Method: Use a mixture of detergent and water (1:10) to spray evenly on the body to keep it moist. The solution makes the film easier to control and allows it to be properly positioned before it is permanently adhered.
The bubble from the sticker is caused by the irregular operation of the sticker. Try to find a sticker store to re-post you! If you want to solve it yourself, you use a flat head plate to scrape from the middle to the surroundings, but I still recommend that you go to the film shop and let them get it! In addition, I will tell you that the stickers should not be posted outdoors, especially on the street, because dust and debris will be posted inside the film, so there will be many bad phenomena, and the effect is also bad!
1. Insurance method: use a utility knife to cut a small mouth from one side of the bubble, and then scrape it with a scraper and a baking gun.
2. Tear it halfway down and slowly stick it up, just do it.
3. Puncture the bubble with a needle and press it flat.
4. Dry paste method, generally there will be bubbles in the inevitable, do not panic ~ Xiao Er I will tell you the solution: first squeeze the small bubble with your fingers, try to squeeze a piece. Then use the needle, or the head of the utility knife, to poke a little, and with a finger press, the bubble is gone. Some small bubbles, you can ignore them. Under the sun for 1-2 days, the air inside will overflow from the material through the increase of temperature! Absolutely flat!